White Wash Color? Trim Color?
mkh926
8 years ago
I called the number provided on one of the posts. I got Mr. Buck's voicemail. I just want to know the trim and white wash color on the wood ceiling. This looks very much like the ceiling we are building at home.
Marshgate, Seabrook Island · More Info
Featured Answer
Sort by:Oldest
Comments (6)
Shayne Shepherd
7 years agoRelated Discussions
Exterior house color
Comments (3)Taupe and oak don't look good together at all as they're too close to each other so they clash. The colors that do look wonderful with oak and similar wood colors are olive and gray greens along with gray blues. We've been putting in a lot of wood trim so I've had to analyze this for the last several months. Here are some colors I think work well with wood: http://www.benjaminmoore.com/en-us/paint-color/mistedfern http://www.benjaminmoore.com/en-us/paint-color/rosemarysprig http://www.benjaminmoore.com/en-us/paint-color/littlefalls At the bottom left hand side of the page are coordinating colors you could use for trim....See MorePicking paint for oak trim
Comments (2)Sorry just to be clear ; its wall colours, furnishings etc colour scheme in general to go with the oak is what I'm looking for advice on! Thanks...See Morecolor suggestion for utility room
Comments (1)grey nuance is a nice colour....Would contrast the cream units...See MoreWhat colour wood? (With Cornforth White walls, White Gloss Kitchen)
Comments (1)A medium color floor is easier to keep looking clean than a dark or light floor. For an open floor plan, I would choose planks. One of the main features in the design of an open floor plan is to draw the eye through the space. A herringbone pattern would be confusing to the eye. Use herringbone in a small room....See More
3pomsmom
7 years ago- PRO
CranCon
6 years ago mkh926
6 years agonanasuesto10
6 years agolast modified: 6 years agoI've done this and you can't believe how simple it is to do! The wood should be clear, w/o knots... I chose V groove pine 5" boards and mixed latex white paint with water....half and half. Sanded the planks, then tack-ragged and rag-painted the paint on and off quickly, overlapping the wet edge. I used 14' boards [so no seams] & mentally divided the board into 4 sections to control paint absorb. I did both sides of the board and the ends to seal it....so boards were pre- finished before they were hung!
Sponsored
Reload the page to not see this specific ad anymore
R.M. Buck Builders