who is the manufacturer of the vanity?
mbeeke
11 years ago
Featured Answer
Sort by:Oldest
Comments (9)
mbeeke
10 years agoRelated Discussions
Need help on flooring!
Comments (21)You should have a professional installer in your area take a look at your home so you can discuss what end result you are wanting. You may need to use an engineered wood. This is still an all wood product and is much more dimensionally stable than solid wood. This is a huge advantage if you are in an older home or in the midwest where humidity levels can drastically change from season to season. A solid wood will cup or curl if humidity and moisture levels are not managed. Your installer should do a moisture test before installation to make sure the installation does not fail. All warranties will be voided if this step is not taken. Also, your transitions will need to be considered. Is the new wood floor going to butt up to tile, carpet, or vinyl? The height difference in the two products will need to be taken into consideration. You will have a greater selection of thicknesses in the engineered woods. Engineered wood should be several plys, all wood. If you choose a solid wood, the hand scraped versions are fantastic for a high traffic area with children. Hickory, Red Oak, most Brazilian Species, and even Bamboo are hard enough to take everyday traffic and still look terrific. Good luck!...See MoreGranite, beautiful or not worth the Money?
Comments (18)ms1zebra, Thanks for your comment and interest! River-rock finished aluminum is a great surface. Its unfinished textured top allows for increased durability for work surfaces. It is resilient with heat, stains, oxidation, but will show signs of use if heavy objects are dropped on or slid across it or cutting is done on it with steel knives. As mainly a lighting manufacturer, we do not heavily promote our tile choices, so we haven't made much of an impact on the tile market. Perhaps when folks think of aluminum as a material, they think about unfinished flat aluminum sheet, which is not a good or even available choice for kitchen surfaces. However, our tumbled finish and thick castings give durability and a great balance between a classic weathered and modern look. Best of all, our aluminum is 100% post consumer recycled, non-mined, locally sourced, made in the USA. We are a Benefit Corporation (B-Corp), triple bottom line company with pioneering experience in sustainable manufacturing. We hope you'll spread the word if you like our product. For more information you can visit our website: http://www.eleekinc.com/tiles/ Thanks again for your interest....See Moreclassic bathroom - tiles or panelling?
Comments (2)post pictures of the room and your choices already please...See Moreclassic bathroom - tiles or panelling?
Comments (1)TRIPLICATE POST> PLEASE ERASE...See Moredcombe
10 years agoCorl Design
10 years agolianng
10 years agoUnison Development
9 years agoCorl Design
9 years agoCarichica
9 years agoCorl Design
9 years ago
Sponsored
Reload the page to not see this specific ad anymore
Corl Design