East Kent Eco - again thank you for your input. As a pro I wonder if you could offer your thoughts on a couple of scenarios 1 - Leave bath where it is - what would be involved in moving the shower 4-6 inches to the centre of the bath? I did consider the P shaped bath and will consider your suggestion for a shorter bath to allow room for the toilet, but I currently had to put in a door stop to protect the shower door from the entrance door handle and I would be concerned about a rounded door being even closer. If I left the bath where it is I have a couple of options, turning the toilet and cistern 90 degrees to the adjoining wall - see above for the considerations there, or I have also considered switching the toilet and sink. I would put the sink facing the wall where the cistern currently is have a large-ish vanity from the base of the bath to the wall, and the if the toilet was where the sink is it would not interfere with the doors for the hot press as the seat would be considerably lower than the sink is currently thus giving me the better access I want. In this scenario the main issue for me would be the toilet would be facing the entrance door, a bit unsightly but if it gave me the space I want I think I could live with the compromise. 2 - A bit more involved, but I have also considered moving the bath sideways along the short length of the room, shower end over the space where the cistern is currently and moving the sink and toilet to the space where the bath is currently. I think this would allow me room for a vanity and maybe also a tall storage cupboard for the towels and linens currently in the hot press. The obvious concern with this is the shower spray in the direction of the hot press, if I got the storage I needed elsewhere in the bathroom I wouldn't be concerned about those getting wet, but would want to ensure I don't end up with a leak over the stairs. Access would also be an issue if repairs were required for the shower pump or the hot water system. You would have to step into the bath to gain access. Is there a solution to waterproof the cupboard?

It small But your cabin sink unit is a good idea as you have storage space and it looks neat. I have changed my bath many times to shower unit and it has leaked every time, some times it has been the plumbers fault or bad design then it was a visitor who let the water spill while showering the last time it flooded the insurers wanted the bathroom TANKED! meaning waterproof walls and floors. This is done by an experienced plumber contractor of repute! as the insurers said too many claims from too many people with bad waterproofing. the insurer said they would not insure again or any other clients who had not got their bathroom water proofed by expert plumber fitters. SO I have gone back to the Bath with a shower enclosed and found it tops for waterproof.

Buying taps for three new bathroom sinks: 80cm, 70cm & 60cm. Any guidance on tap dimensions welcome.

Looking for some feedback for our master bedroom en-suite in our new build . I have 2 design options attached - but I’m open to others ideas if any one has any suggestions. All advice appreciated.